2018 Marathon Motors Catalog

GENERAL INFORMATION

STORAGE PROCEDURES In the event that long-term storage of motors is required, Regal recommends the following precautions and procedures. This information is also contained in “Installation, Operation and Maintenance Instructions” (SB181). A. Keep motors clean 1. Store indoors 2. Keep covered to eliminate airborne dust and dirt. 3. Cover openings for ventilation, conduit connections, etc., to prevent entry of rodents, snakes, birds and insects. B. Keep motors dry 1. Store in a dry area indoors 2. Temperature swings should be minimal to prevent condensation. 3. Space heaters are recommended to prevent condensation. 4. Treat unpainted flanges, shafts and fittings with a rust inhibitor. 5. Check insulation resistance before putting motor into service. C. Keep bearings lubricated 1. Once per month, rotate shaft several turns to distribute grease in bearings.

STOCK, NON-STOCK AND BUILD UP MODELS Standard motors listed in this catalog, as indicated with a check mark ( √ ) next to the catalog number, are normally in stock. There is no minimum order quantity or minimum billing charge associated with stock motors, unless stated otherwise in your quotation or agreement with Regal. Production of non-stock catalog models and all build-up models is subject to minimum order quantities or setup charges listed below. 48-140 Frame = 24 piece minimum 180-250 Frames = 5 piece minimum or $250 set up/model 250-320 Frames = 5 piece minimum or $300 set-up/model Build-up motors must be thoroughly described at time of order, and/or associated with a formal quotation issued by Regal. Inclusion of product features for similar motors documented in this catalog should not be assumed. SERVICE For service on any Marathon ® motor, contact your nearest Regal authorized service station. For a complete listing of all domestic and foreign service stations, refer to www. regalbeloit.com. OPERATION AND MAINTENANCE For information on operation and maintenance, please consult the manual or card shipped with your new motor. Additional copies of “Installation, Operation & Maintenance Instructions” (brochure SB181) are available upon request or through our website, www.regalbeloit.com.

GENERAL INFORMATION

2. If unit has been stored more than one year, add grease before start-up (refer to lubrication procedure).

DIMENSION DRAWINGS See regalbeloit.com or request certified drawings through your Regal sales engineer, representative or local Marathon motor distributor.

11