Erie Products Catalog 2025

Accessories JAMES HARDIE: FIBER CEMENT SIDING ACCESSORIES

jameshardie.com

Hardie® Trim NT3™ Boards

Don't Forget! ColorPlus® Touch-Up Kit Edge Coater Used to coat exposed edges and nail heads. 16 oz. JH16TU OSI QUADMAX Caulk

Nominal (Actual) Width 4" (3-1/2") SPECIAL ORDER 5" (4-1/2") 6" (5-1/2") 8" (7-1/4")

5/4"

4/4"

JH54

JH44

ARCTIC WHITE ONLY ARWH

JH55

SIDING

JH56 JH58

JH46 JH48

12" (11-1/4") JH512

L

B

Hardie® Trim Tabs Flat and corner tabs for a more aesthetically pleasing installation Corner Tabs 8" Tabs, Box of 50 JH8COTA Flat Tabs Box of 100 JHFLTA TAB SPACING NOTE: Windows and rakes every 12". Corners every 24". QUICK START INSTALLATION GUIDE HardieInstallation.com

J

C

E

A

K

G

I

D

H

F

GET THE BEST PRACTICE GUIDE

IMPORTANT: This document is not intended to take the place of James Hardie published installation instructions. Failure to install and nish this product in accordance with applicable

building codes and James Hardie published instructions may lead to personal injury, affect system performance, violate local building codes, and void the product only warranty.

For the latest set of complete installation instructions applicable to your jobsite location, visit HardieInstallation.com or call 1-866-942-7343 (866-9-HARDIE)

Created by Made by Made from the Noun Project

A

B

C

D

Slabs, Path, Steps to Siding

Roof to Wall

Horizontal Flashing

Kickout Flashing

Min. 1/4” clearance. Do NOT caulk.

Kickout flashing 4”x 4” min.

Z-Flashing

2”

2”

E

F

I

G

H

Deck to Wall

Ground to Siding

Gutter to Siding

Sheltered Areas

Mortar/Masonry

L-Flashing

Z-Flashing

Z-Flashing

Min. 1/4” clearance

2”

Min. 1/4” clearance. Do NOT caulk.

Z-Flashing

6” USA 8” CANADA

Min. 1/2” clearance

1”

J

K

L

Drip Edge Flashing

Valley/Shingle Extension

Butt-Joint Flashing

Blocked Penetrations

Z-Flashing

Extend shingles at least 1” out from the fascia when gutters are present

Min. 1/4” clearance above flashing. Do NOT caulk.

Joint Flashing Do NOT caulk joint

IMPORTANT FASTENING INFORMATION: James Hardie ® siding, trim and soffit products must be installed in a manner that meets local building code and wind load requirements. It is the responsibility of the installer, builder, architect or other building professional and the home or property owner to ensure the fasteners and fastening schedules used result in an installation that is code compliant. Consult ESR 1844 and ESR 2290 or other applicable, local code compliance documentation for guidance on fastener selection and placement to achieve design wind loads for the specific James Hardie siding product, framing type, building height, wind exposure category and other factors relevant to your project. For special circumstances outside the scope of these documents, please refer to the Technical Document library at www.jameshardie.com or contact James Hardie’s Technical Services at 1-888-J-HARDIE (1-888-542-7343).

138

All prices subject to change. Not responsible for typographical errors. See eriematerials.com/updates for major price announcements.

ERIEMATERIALS.COM

TM